F3D-DK-0014Concept / تصميم مبدئي

Entwine lily sculpture

Three lilies on three entwined stems, a bud, an opening flower and a full bloom, in one printed piece

Not on sale yet

Designed and checked in CAD, not printed yet. The pictures are renders, not photographs. The price and ordering come once a printed prototype passes its tests.

Size
167 × 104 × 196 mm (W × D × H)
Base
Ø100 × 7 mm, on 6 silicone pads
Weight
about 122 g

Three stems rise from one foot, wind round each other in an open twist, close again at a node and part into three lilies: a closed bud low at the front, a flower starting to open behind it, and a full bloom on top whose six tepals curl back past level around six stamens and a pistil. Eight long leaves rise with them; five arc out and hang.

Every leaf and tepal carries a raised midrib and fine parallel veins modelled into it, not painted on. The piece stands on a bevelled base 100 mm across, on six clear silicone pads.

One piece of high-gloss PLA, 167 × 104 × 196 mm. It prints upright with supports under the curls, which are removed and the undersides cleaned by hand. A decorative piece for a shelf, a sideboard or a desk: lift it by the base, and keep it out of hot sun.

Specs
Size
167 × 104 × 196 mm (W × D × H)
Base
Ø100 × 7 mm, on 6 silicone pads
Weight
about 122 g
Material
High-gloss PLA, one piece
Colour
Charcoal, high gloss (pearl ivory silk PLA under consideration)
Detail
Veins 0.18–0.20 mm deep; tepals 1.4–2.4 mm thick
Care
Dust with a soft brush; indoors, below 50 °C

You might also like